I think I’ll try using a jig saw on a scrap piece first, and if I cant get a good cut then I might splurge and get a scroll saw.
Does anyone have any good suggestions on scribing? How about the use of a template?
I am looking for ideas on both cutting and scribing. I thought about using a jig saw but I’m worried about splintering. I guess it depends a lot on the blade I use. I have a router and wonder if it can be used? I have limited experience using the router. I also have an oscillating spindle...
I am installing ¾ x 2 ¼ inch prefinished red oak hardwood on my second floor hallway. I have a circular staircase with a ¾ inch oakbull nose installed by the builder. Can anyone give me suggestions on how to cut my prefinished hardwood so that it perfectly matches the curve of the bullnose...
Thanks for everyone’s response, but I am still confused. Every ware I read says that if installed over OSB in the same direction as the joist you may end up with sagging between joist and a greater possibility of squeaks. Has anyone done this? What is it like a few years later? I have my...
Hi everyone. I plan to install about 1000 sq ft of pre-finished 3/4 x 2 1/4 inch red oak on my second floor. I will be installing it in the hallway and 4 bedrooms. The joist in the hallway and one bedroom run side to side. In two of the bedroom the joist run front to back. The problem I have is...