Recent content by bobbyt8888

I've just laid a 3/4" hickory solid wood floor with glue assist on 3/4" plywood using staples and Loctite urethane adhesive applied in a serpentine pattern. In another thread I was advise to save 5% or so extra flooring in the event board replacements are needed. My question is since the floor...

These replies lead me to ask a question on board replacement which I will ask in a new thread: https://www.flooringforum.com/threads/3-4-t-g-board-replacement.6716/post-79379

It is Dan. How do you determine how much enough is?

Yes, that is correct.

Thanks everyone. I bought a tub of R851. If I use some now and then again a month or two from now, will the foil keep it usable until then?

Agreed, I need the correct trowel. Now I just have to find a smaller quantity of the adhesive.

Would the Loctite urethane adhesive that I used for the assist be considered "moisture inhibiting"?

We've laid the 3/4" hickory Mullican floor on the entire 1st floor (basement below) using staples and glue assist. Now there is a short, narrow hallway that is a step down from the floor. It is 36" wide by 8' long and is on a concrete slab. How much trouble would I be in if I simple glued it...

Thanks for the replies. I'll just glue it since I can't get under there to hand nail.

I'm finishing up an installation of 5" hickory in our kitchen and I'm now at the toe kick course. I'm stapling and using serpentine urethane glue assist with not vapor barrier, per Mullican's instructions. How do I fasten the last course? I can't get anything in there to nail it. Can I simply...