Help Support Flooring Forum - DIY & Professional:
-
-
Iinstall4you replied to the thread Discussing politics and religion.My neighbor across the street died & the house was sold. When I saw renovations under way I naturally went to meet my new neighbor. I...
-
Iinstall4you replied to the thread How to tie in to existing.Real quick question in case anyone's on the site right now. In replacing the threshold board as discussed above, I realized I'll have...
-
Iinstall4you replied to the thread How to tie in to existing.I knew there was a way! I have a laser but I don't use it often because it's older & lacking in features; however, it will be great for...
-
Iinstall4you replied to the thread How to tie in to existing.Thanks for suggestions. I wish I had pulled baseboards from the start, but this is the last room I have to do in the house. The powers...
-
Iinstall4you replied to the thread How to tie in to existing.Thanks JPfloor, Incognito, & Floorist for your thoughts. I now think leaving the cross board is the best plan. Even though I found some...
-
Iinstall4you replied to the thread How to tie in to existing.Quick update. The powers that be have instructed me that the change-over point from old sheen to new sheen must be at the door. That...
-
IGreetings to All. I’ve got an “OH NO” situation & need a quick solution if anyone’s willing to educate me. Seventeen years ago, I...
-
-
Iinstall4you replied to the thread How flat is flat enough?.So if I read JPfloor & CJ correctly, for a couple of plywood joints with misaligned surfaces (less than 1 sq ft each) I'll use some...
-
Iinstall4you replied to the thread How flat is flat enough?.Thanks for your answer C.J. I’ll try to clarify what I’m asking. The area I’m dealing with is about 6’ X 12’. The 12’ sides of the...
-
IGreetings to all. I just posted my nubie intro & I'm in a time crunch, so Ill jump right into my request for advice. I'll start by...
-
IHi everyone. This is my Nubie introduction. Sorry if it's terse. I'm usually long-winded, but I'll save that for later. I know it's...
-
-
Loading…
-
Loading…
