Recent content by John Mathey

My next challenge is this, coming down a wall near my door, the door is angled, I know I can cut the laminate along the angle, that's not an issue, there is a small little indention on the wall that goes in and out ( photos attached), I'm not quite sure what to do about that. it's very small...

Thanks Mark, Yes by ripping that first row down I did leave a little extra to allow for a gap along that wall, it looks perfect now. like you said, you need to lay it out ahead of time to plan for these things , I'll know for the next room. thanks again!!!

I guess what I would need to do is rip cut the first row to bring the 2 rows even with the corner , anyone have any other ideas. thanks

I have a corner I'm trying to floor around, my issue is the number of planks I needed to get from the beginning to the where the abutment of that corner is 2 then a small 2 inch piece, meaning I had to cut the groove side off leaving the cut corner exposed. I have two rows in place and was...