Search results

Ok, leveler helped some but still not level. The LVP has an attached underlayment. I have also been rolling out a separate underlayment for the rest of the house. If I skip the extra underlayment just where the ridge is to assist with the leveling is that going to cause any issues. It’s over...

That’s what I just did, it helped some. Hopefully enough. Thanks everyone for your responses.

In looking further under the basement, there is a block wall that runs under that ridge separating two parts of the basement. The joists from each side terminate on top of that wall and under the ridge. Apparently that wall is slightly too high. So short of pulling the entire sub floor floor...

Yes, it’s over a basement. I figured high joist also until I went down and checked.

In the middle of renovating a very old home and putting down rigid LVP. I have used floor leveler, grinder, sanding to get most of the problems areas level. But this little hallway alcove has me baffled. It has 4 entry ways into different rooms and all are pretty level, but right in the...