I can really use some help. I’m a DYI and remodeling my bathroom; I was cruising along preparing the shower to install backer-board and ran into an unexpected issue. I have a metal flashing that runs from the window sill down the wall about 2 inches. (SEE ATTACHED PICTURE) My question is how do I address this metal flashing when preparing the wall for backer-board/tile?
A. Cut the metal
B. Unscrew and lift it up the flashing, placing the backer-board underneath.
C. Run the backer-board up to the flashing, accepting that is the limit for tiling the wall.
D. [Insert Your Suggestion]
Any help would greatly be appreciated!!!
JJ
A. Cut the metal
B. Unscrew and lift it up the flashing, placing the backer-board underneath.
C. Run the backer-board up to the flashing, accepting that is the limit for tiling the wall.
D. [Insert Your Suggestion]
Any help would greatly be appreciated!!!
JJ
Last edited: