Help Support Flooring Forum - DIY & Professional:
-
-
CChaucer replied to the thread Stair Nose Transition.tks..actually the stock bullnose is about 1 inch wider. I cut it instead of the plank. I can cut the plank back 1 inch and leave the...
-
CChaucer replied to the thread Stair Nose Transition.Ha, your a funny man Re: Silicone; To hold the floor down or fill a gap? I think your right aboutthe transition...even if I got to...
-
CChaucer replied to the thread Stair Nose Transition.Hi, I've been playing with it today. Have it pretty matched up, but due to the fact that it's a floating floor, the edge that is next...
-
-
CChaucer replied to the thread Stair Nose Transition.Hi, Tks for the reply. It's the board behind the riser that is too high. It's looks like a 2 x 8 nailed to the stairs. It goes...
-
CHi, Looking for some advice how to handle my stair nose transition on last step to floor. A couple of things. 1. There is a height...
-
-
CChaucer replied to the thread Stair caps.Ha...your so right..tks, I may give a small section a try and see how it comes out...thank you
-
CChaucer replied to the thread Stair caps.@havasu Although I've made some wedges and they look ok, that is really what I want to do. Are you saying make a new skirt board with...
-
CChaucer replied to the thread Stair caps.@highup , Thank you for the suggestions. I did stain an extra tread before making the cuts. I've made a couple wedges. I used a...
-
CMiter saw or a table saw if you have a sled. The piece will be small so keep an eye on it and where it goes when you’re cutting it.
-
CI would definitely try the wedges first. If you don’t like the way they look then maybe a new skirt board is the ticket.
-
CYa... And don't forget your eye protection. They almost never go where you think they will....
-
CChaucer replied to the thread Stair caps.tks..I'll give it a try. What is a technique to get the correct angle? Measure the width of the widest part and then???
-
CChaucer replied to the thread Stair caps.tks..I'll give it a try. What is a technique to get the correct angle? Measure the width of the widest part and then??? Do you think...
-
CChaucer replied to the thread Stair caps.Hi, I do. What would be a good technique and tool to cut it. Thank you
-
CChaucer replied to the thread Stair caps.Hi, My project is complete..thanks to all the help here. I'm happy with the outcome excpet for one aspect. Because the skirt was not...
-
-
-
Loading…
-
Loading…
