Recent content by Jen81407

Thanks for getting back to me. With a floating floor is it possible to cut the damaged piece out, fix the floor and then reinstall a piece and glue it where the joints would be?

We have MSI Prescott floating LVP installed throughout the house and have a few spots that dip slightly when you step on them along the long side of the plank where they connect to the adjacent plank. Meaning one plank goes slightly higher than the adjacent plank. We suspect some may be due to...

Hi everyone, Wanted to reach out to the group to see if you have a recommendation on a jigsaw blade to make cuts in SPC LVP flooring. My dad tried wood, laminate/LVP, and metal blades and they all seem to work, but dull after 1 cut or so. Is there a blade better suited for cutting this product...

This is the only one Home Depot had.

Hey everyone, so today we went around the space checking the level and there are only two bad areas. One has a high spot that we tried grinding, with little success (angle grinder just didn’t seem to cut it). The other has a low spot which we filled with self leveler. The low spot is a lot...

Hi Mark, I appreciate your thorough explanation. We do have a 16’ baseboard to use to check on the leveling. My dad was originally coming up to install baseboards and is now stuck helping me with this mess now ;( Now that you say it was over watered it makes a lot of sense when I saw how it...

Thanks for the reply, Mark. The two areas I’m highlighting are definitely the worst areas. My LVP says 1/8” within 6’. Is there a best practice on how to do this overall topographical check or just take a 6’level and move across the floor? I’m attaching a photo of a more general view of the...

Long story short, I had a good contractor who hit some rough times and turned into an awful contractor. Tile and carpet were removed from concrete slab and he poured self leveling cement over parts of the area that previously had tile and a lot of big holes after the tile demo. My dad and I want...