I measured areas to repair in a large restaurant kitchen. Two damaged areas need new Gypcrete brought back to the level of the existing. It will then receive new gray quarry tiles.
How do you prep the edges where the existing Gypcrete meets the new?
Does one prep he edges where they meet with the "correct" primer and call it good
.........or is it possible to shape or profile the edge to stabilize the joint?
The larger area is just 12 by 6 or less. It will be one and a half inches deep.
The substrate is plywood.
How do you prep the edges where the existing Gypcrete meets the new?
Does one prep he edges where they meet with the "correct" primer and call it good
.........or is it possible to shape or profile the edge to stabilize the joint?
The larger area is just 12 by 6 or less. It will be one and a half inches deep.
The substrate is plywood.