highup

A friend of mine paid 2600 or a new 16 footer with installation. That was over a year ago. He and a friend removed the old door to save...

Yeah. I’ve got a question out to the manufacturer. Hopefully they’ll get back to me. The one thing I was thinking is that maybe it’s...

Here's the grin I'm trying to reduce or improve. If I do them as is, all 5 doorways will look like this. I'm not happy with this look .

Using my offset laminate trimmer with a Wilsonart slot bit I can create two steps on the edge of the hardwood floor. Two steps in the...

5 months is farther than I can remember. Here's my mockup a week after I initially measured the job. 🤧 Bevels anyone? 🫣

I'm not against feelings. They get used to put one group or one race against the other...... by politicians and almost always liberal...

I found an old Wilsonart spline bit. I'll checking locally for different size bearings to reduce the cut depth. The blade thickness is...

You're way ahead of me. I borrowed a stretcher from the shop so that I could put two stretchers side by side to assist making a closet...

You're in the safe zone, the fires are past or not close to you?

I was 🤔 ....the Nuclear Power State. The future is now!

Never heard of this guy before. I like him already and I just started listening. Skip ahead to where he plays Adam Corolla interviewing...

A car is on the train tracks and can't move. Liberals will debate amongst themselves why the train was going 50 mph instead of 15 and...

That little buckled area i can probably straighten a little. The seam is that pattern line starting at the edge of the door trim.... IE...

An afterthought was to notch or back bevel the hardwood, creating a taper. Two variations. An 1/8 inch notch (red), or a taper. ....no...

Nope, I knew early on there would be no thresholds. That just wasn't gonna happen. I wouldn't need to pull the carpet out if I wanted...