Recent content by DennisT

I guess I just have that animal magnetism. ;)

I hadn't logged on for quite a while (many months). I then logged back on the other day and immediately got a forum survey email. 5 minutes later I got a PM from emi9541 : Flooring Forum - DIY & Professional...

So anyone can openly carry a gun? Doesn't that seem a little silly? Who would want to be a police officer in that environment?

Like all things in life, it depends. You can add another layer and that may look best. The problem comes with outside doorways and stairs. Too large of a change and you can have problems there. Depending on how much you need to add, plywood is the best but will be more expensive than...

notalwaysright.com You could spend hours there reading about how bad people can be.

Yeah, and the logical thing would be to fix the broken parts instead of throwing the entire law away. Based on how congress works now, repealing the law and nothing will replace it for a long time.

Did a Google search on that and this was the 1st thing I got: http://www.snopes.com/crime/statistics/ausguns.asp

And just about every other. The ACA was passed to address this, but congress seems hell bent on getting rid of that.

What's wrong with bamboo? Strand bamboo is very durable and eco friendly. It is harder to install, but other than that ???

Like most things in life, it depends. How thick is your subfloor? Ply or OSB? How flexible is the subfloor (jump up and down on it in the middle of the room). Think of the subfloor as a system. If it moves now when you walk across it it'll continue after the finish floor is laid. If you...

Have you determined which nailer you're going to use? Strand is really hard and dense. Too big of a gauge and you'll split the tongues off. I installed a few 100 sqft of strandwoven timber. The same as bamboo but made from wood fiber scraps. I ended up renting a Primatech 550 (18GA cleats)...

How far off is the floor from the Bamboo mfgr's recommendations?

I can't believe that is real.

Typically one would run everything through a planer to get it all in equal thickness. Then through a joiner to square them up. Then Use biscuits to align and make the joints stable. Glue & clamp. Then sand both sides smooth. Finally treat the wood with something non toxic.

c. Not that I'm aware of.